revolving header hack

Friday, 19 August 2016

The Maker Challenge: Week 5 Review

We spent a while refining our goals for the STAGES of the project that we discussed last week and started creating a shopping list of essential supplies that we will require to achieve STAGE 1




Along the way we came across these different drive units that may be of use. 



We also had a good deal of discussion about the size of boat that we need to fulfil STAGE 1.  A small, 3D printed boat was suggested however we agreed that it might not cope with rough water when we get to STAGE 2 — meaning we'll have to start again.

A hull would be researched, seeking the advise of a local model boating expert as to the size of motor and prop that we will need to achieve 5-10mph cruise speed.


No comments:

Post a comment